Imprint

   Airfit GmbH & Co. KG

Gewerbegebiet Zingsheim-Süd 40 • D-53947 Nettersheim

Tel.: +49 (0) 2486 80 28 19  •  Fax.: +49 (0) 2486 80 27 37

www.airfit.eu • post@airfit.eu

The only approved waste water

interior reducers for horizontal installation

that DO NOT NEED A SLEEVE!

DN 108/50* eccentric

For thick-walled pipes with an internal diameter

101-103 mm. Suitable for ...

... Wavin: SiTech-Rohr

Dyka: PVC-U-Ultra-3

Poloplast: Polo-Kal-Ng

Piplife: Master 3

 Valsir: Tri-Plus

Geberit: Silent-PP

Geberit: Geberit-PE

KG 2000 etc.

Item no. 10850IR

The typical problem on almost every construction site:

Mortise the drain pipe in the
floor plate to the next sleeve
with the caulking hammer.

Use force to pull out the drain pipe.

Clean sleeve and sealing element.

Insert reducer.

Measure the pipe connector.

Cut the pipe connector to size.

Insert the pipe connector

 Remove rubble.

Reseal the floor plate with concrete.

1.

 

 

2.

3.

4.

5.

6.

7.

8.

9.

Time required: approx. 28 min.

Time required: approx. 1 min.

 

Airfit Waste water interior reducer

Cut pipe flush to the ground with angle grinder.

Insert Airfit waste water interior reducer – save time and money.

1.

 

2.

conventional

DN 110/50*

Item no. 11050IR

  20 times

   quicker

installation!

 

* Tested and approved by DIBt

[German Institute for Structural Engineering] Z-42.1-366

 

 

Suitable for KG pipes (DIN EN 1401-1) and HT pipes (DIN EN 1451-1)

 

 

*Fire behavior: Tested as per

DIN 4102-B2, EN 13501-1-E, EN 11925-2.

 

 Reducing piece
DN 75/50*

Item no. 7550IR

Reducing piece 
DN 90/50*

Item no. 9050IR

 Reducing piece
DN 90/75*

Item no. 9075IR

 Reducing piece

DN 110/50*

Item no. 11050IR

Reducing piece
DN 110/75*

Item no. 11075IR

  Reducing piece 
DN 110/90*

Item no. 11090IR

  Reducing piece
DN 125/110*

Item no. 125110IR

  Reducing piece
DN 160/50*

Item no. 16050IR

  Reducing piece
DN 160/110*

Item no. 160110IR

   Reducing piece
DN 160/125*

Item no. 160125IR

For underground pipes

Reducing piece
DN 125/110

Item no. 125110KG

Reducing piece
DN 160/110

Item no. 160110KG

 Reducing piece
DN 160/125

Item no. 160125KG

For pipes
KG & HT.
Exterior diameter
188 mm (DN 200)

Eccentric
DN 200/50

Item no. 20050IR

Eccentric
DN 200/110

Item no. 200110IR

Eccentric
DN 200/125

Item no. 200125IR

Concentric
DN 200/160

Item no. 200160IR